# wio sx1262 board on 'hat' header, for pymc_repeater or meshtasticd
+
+
[](./nebra-pinheader-sx1262-photo.jpg)
+
[](./nebra-pinheader-sx1262-pinout-note.jpg)
+
+
This pinout is inspired by/compatible with the [Zebra Hat](https://github.com/wehooper4/Meshtastic-Hardware/tree/main/ZebraHAT). The Zebra Hat is different from other LoRa hats because it considers the limited number of actually connected pins in the Nebra miner. By being compatible with that board, after connecting all the wires, [pyMC_Repeater](https://github.com/rightup/pyMC_Repeater) just works when picking the Zebra Hat board type.
+
+
Full pinout description (you can use [pinout.xyz](https://pinout.xyz/pinout/spi) instead of the second photo above):
+
+
* SX1262 MOSI, MISO and SCK to Nebra SPI0 MOSI, MISO and SCLK
+
* SX1262 DIO1 to Nebra GPIO22
+
* SX1262 BUSY to Nebra GPIO27
+
* SX1262 RST to Nebra GPIO17
+
* SX1262 NSS to Nebra GPIO24
+
* SX1262 3V3 to Nebra 3V3
+
* SX1262 GND to Nebra GND
+
+
There is a GND right next to GPIO17, and a 3V3 between GPIO22 and SPI0 MOSI.
+
If you use those two, all pins are in a single straight line except for the NSS one on GPIO24.
+
# unsorted notes, to be sorted
via https://helium.nebra.com/datasheets/hotspots/outdoor/Nebra%20Outdoor%20Hotspot%20Datasheet.pdf
