commit e3ce59

2026-01-29 20:16:55 Peter van Dijk: document meshcored config for sx1262 setup

0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9

`miners/nebra outdoor.md` ..
@@ 1,6 1,6 @@
	# Nebra Outdoor

-	## wio sx1262 board on 'hat' header, for pymc_repeater or meshtasticd
+	## wio sx1262 board on 'hat' header, for pymc_repeater or meshtasticd/meshcored

	[![Wio sx1262 (from esp+wio kit) connected to Nebra pin header](./nebra-pinheader-sx1262-photo.jpg?thumbnail=250)](./nebra-pinheader-sx1262-photo.jpg)
	[![pinout note for sx1262 on nebra pin header](./nebra-pinheader-sx1262-pinout-note.jpg?thumbnail=250)](./nebra-pinheader-sx1262-pinout-note.jpg)
@@ 24,6 24,15 @@
	If you use 17 and 9 for 3V3 and GND, all pins are in a single straight line except for the NSS one on GPIO24.
	SX1262 RF_SW, VIN, and pins like D5, D6, D7, do not need to be connected.

+	This setup also [works](https://github.com/meshcore-dev/MeshCore/pull/1137#issuecomment-3819952554) with [meshcored](https://github.com/meshcore-dev/MeshCore/pull/1137) with this `meshcored.ini` snippet:
+
+	```
+	lora_irq_pin = 22
+	lora_reset_pin = 17
+	lora_nss_pin = 24
+	lora_busy_pin = 27
+	```
+
	# unsorted notes, to be sorted

	via https://helium.nebra.com/datasheets/hotspots/outdoor/Nebra%20Outdoor%20Hotspot%20Datasheet.pdf